Whole-system duct and dryer vent check with before-and-after photos - you see exactly what came out of your vents
That "$99 whole-house special" is a bait ad - the real number appears once they are in your hallway, or the "clean" is a shop-vac at the register. We photograph the inside of your ducts before and after instead.
Before
After
Before
After
Before
AfterFull System Cleaning in Plano, TX
Full system cleaning covers every component that moves air through your home: the supply ducts, return ducts, plenum chambers, registers, grilles, and the air handler cabinet itself. A single dirty register or an uncleaned plenum – the large distribution box that feeds all your duct runs – leaves contaminated air cycling back into the rooms you just cleaned. In Plano, where homes built between 1990 and 2015 often have flex-duct systems that trap debris in every corrugation, a partial clean is rarely a real clean.
If you’ve been quoted a “duct cleaning special” under $150 for a four-bedroom house, what you’re likely getting is a shop-vac run through the two or three most accessible registers. That’s not a full system clean. Our Air Duct Cleaning in Plano service is built differently: written price before any panel comes off, a camera inside every run, and a documented photo record when the crew leaves. Call (469) 452-7766 and we’ll put a written price in front of you before you commit to anything.
When You Need Full System Cleaning
Most Plano homeowners don’t realize there’s a problem until an air quality symptom or an HVAC inefficiency makes it obvious, which is why our Residential Duct Cleaning addresses the full system. Here are the situations where full system cleaning – not a spot treatment – is the right call:
- Your home was built or renovated between 1995 and 2015. Flex-duct systems installed during Plano’s biggest growth period accumulate debris in the corrugated inner liner. Construction dust, insulation fibers, and years of normal operation compound in ways rigid metal duct does not. A camera at the first elbow typically shows a debris ring within two feet of the supply plenum.
- You’re seeing inconsistent airflow room to room. If the bedrooms in the back of the house run 3-5 degrees warmer in summer than the front rooms, restricted duct runs are a likely cause. Debris buildup at bends and transitions reduces static pressure and shifts the load to your HVAC system rather than the registers.
- A previous cleaning produced no before-and-after documentation. If the last company that touched your system couldn’t show you a photo of what was inside the duct before they claimed to clean it, there’s no reliable way to know what actually happened. Full system cleaning starts fresh with a documented baseline.
- You’ve had a rodent or pest intrusion. Plano’s older neighborhoods – especially near Legacy Drive and the corridors backing up to Rowlett Creek – see occasional rodent activity in duct systems during fall. Dander, droppings, and nesting material don’t come out with a single-point extraction. Every run needs to be accessed and cleared.
- Dust returns within days of a filter change. A clean filter and a dirty duct system are working against each other. If fine particulate is resettling on surfaces within 72 hours of a new filter, the source is inside the system, not in the ambient room air.
- You’re selling, buying, or moving into the home. Sellers in Plano’s competitive market increasingly use a documented full system clean as a disclosure item. Buyers use it as a baseline. Either way, a photo record from before and after the cleaning is a concrete deliverable – not a verbal assurance.
Our Full System Cleaning Process
Every full system cleaning CleanRun performs in Plano follows the same documented sequence. Nothing is skipped to save time, and nothing is added to inflate the scope after the fact. The written price you receive before we start reflects exactly the steps below.
- Pre-cleaning camera inspection and documentation. Before a single panel comes off, we run a camera through each duct run and photograph what’s there. This is the baseline record – the before photo you’ll receive as part of your job documentation. We note debris type (dust cake, construction particulate, biological matter), approximate depth at each obstruction point, and any visible damage to the duct liner. In Plano homes with older flexible duct, the camera frequently shows debris accumulation at every elbow, not just the terminal ends.
- System isolation and negative-pressure setup. We connect a negative-pressure extraction unit – equipment from Nikro’s professional line – to the main trunk at the air handler. Negative-pressure extraction means the system draws air toward the machine rather than pushing dislodged debris back into the living space. Every register in the home is sealed before extraction begins, and we verify the pressure differential before agitation starts.
- Mechanical agitation of every duct run. Using Rotobrush rotary brush equipment, a flexible rotating brush clears debris from the interior of each supply and return run, working from the register back toward the trunk. This step is what separates a full system clean from a vacuum-only service. The brush breaks the adhesion of settled particulate and pushes it toward the extraction point while the negative-pressure unit pulls it through. Every run is brushed – not just the ones closest to the air handler.
- Plenum and air handler cabinet cleaning. The supply plenum and return plenum – the distribution and collection chambers at the air handler – are cleaned separately. These are typically the highest-concentration debris zones in the system because every duct run terminates here. The air handler cabinet interior, including the blower wheel and evaporator coil housing, is cleaned and inspected as part of the full system scope.
- Register and grille cleaning. Every supply register and return grille is removed, cleaned of settled dust and debris, and reinstalled. Registers that show corrosion, damaged fins, or warped dampers are flagged in the job record. Replacement is your call; we document the condition and move on.
- Post-cleaning camera verification and photo record delivery. After extraction is complete and registers are reinstalled, we run the camera through each duct run a second time. The after photos go into your job record alongside the before photos. You receive both sets – not a summary, the actual documentation. This is the standard deliverable on every CleanRun job, backed by the 365-Day Done Right Promise: if the after photos don’t show a material difference from the before photos, we make it right.
BeforeAfterFull System Cleaning Pricing in Plano
Full system cleaning in Plano typically runs between $375 and $750 for a single-family home, depending on system size and configuration. That range is wide because duct systems in Plano vary significantly: a 1,600-square-foot home off Coit Road with a single-story flex-duct system is a different job than a 3,800-square-foot two-story near Legacy West with two air handlers and a mix of rigid and flexible duct.
Under Haven Standard Clause 1, every job gets a written price before any work starts. “Call for a quote” doesn’t exist here – you’ll have a number on paper before a single panel comes off.
| Home Size / Configuration | Typical Price Range |
|---|---|
| Up to 1,800 sq ft, single-story, one air handler | $375 – $475 |
| 1,800 – 2,800 sq ft, single or two-story, one air handler | $450 – $575 |
| 2,800 – 4,000 sq ft, two-story, one air handler | $525 – $650 |
| Dual air handler systems, any size | $600 – $750+ |
| Post-construction or renovation clean (heavy debris) | Quoted separately after camera inspection |
What affects your specific price:
- Number of duct runs (supply and return separately) – each run is photographed and cleaned individually
- Duct material: flex duct requires more agitation passes than rigid sheet metal
- Access points: second-story systems with attic-mounted air handlers in Plano often require additional setup time
- Contamination type: standard dust accumulation is priced differently than post-renovation debris or biological matter
- System age and condition: duct runs that show liner damage or disconnected sections are flagged before pricing – repair scope, if needed, is quoted separately and does not start until you approve it in writing
If you have a written estimate from another company, bring it. CleanRun will put its own number next to it in writing, at no charge. That’s the Free Second Opinion – available on any written estimate, no appointment required to get the comparison.
Call (469) 452-7766 to get your written price. The estimate is free, and the price you’re given before work starts is the price on your invoice when it’s done.
FAQs – Full System Cleaning
How is full system cleaning different from a standard duct cleaning?
Full system cleaning covers every air-moving component in your HVAC system – supply ducts, return ducts, both plenums, the air handler cabinet, and every register and grille – which goes beyond basic Air Duct Cleaning services. A standard duct cleaning, particularly from companies advertising low flat-rate specials, typically covers only the accessible supply registers and skips the return side, the plenums, and the air handler itself. In Plano homes, the return plenum alone commonly holds more debris than all the supply runs combined, because it draws air from the entire house before passing it through the filter. Leaving it uncleaned means you’ve cleaned the downstream side of the problem and left the source in place. Call (469) 452-7766 for a written price that specifies exactly what’s included – before any work begins.
How long does full system cleaning take for a typical Plano home?
For most single-story homes in Plano between 1,600 and 2,400 square feet, full system cleaning takes between 3 and 5 hours. Two-story homes or dual-system configurations typically run 5 to 7 hours. The camera inspection at the start and the post-cleaning camera verification at the end each add time, but they’re what produce the documentation you receive as a standard job deliverable – not optional add-ons. Homes in Plano’s older neighborhoods near Downtown or the Spring Creek corridor that were built with mixed rigid and flex-duct systems tend to take longer than comparable square-footage homes with uniform flex-duct systems.
How often does a Plano home need full system cleaning?
For most Plano households, full system cleaning every 4 to 6 years is a reasonable baseline. That interval shortens to 2 to 3 years if you have pets that shed, if anyone in the household has asthma or allergy sensitivities, or if the home has had recent renovation work. Homes built during Plano’s 1990s and early 2000s growth period with original flex-duct systems that have never been cleaned should treat the first cleaning as a reset – after which a documented interval makes sense. The photo record from each CleanRun cleaning gives you an objective reference point: the before photos from your next cleaning show whether the interval was appropriate or whether you’re building up debris faster than expected.
Is full system cleaning worth it if my HVAC system is only a few years old?
A newer HVAC unit doesn’t mean clean ducts. If the duct system itself predates the equipment – which is common in Plano, where homeowners replace air handlers and condensers while keeping original duct runs – years of accumulated debris remain inside the existing distribution network. Construction activity from a nearby addition or a remodel can also load a duct system with fine particulate within weeks, regardless of equipment age. The camera inspection at the start of every CleanRun job gives you an objective look at what’s actually inside – before any money changes hands – so you’re making the decision based on documented evidence, not a sales pitch. Call (469) 452-7766 and we’ll schedule an inspection with a written price before any work starts.
What CleanRun Documents on Every Plano Full System Clean
Tomas Reyes built CleanRun’s documentation standard from the first job in 2013, and it hasn’t changed: every customer gets a written price before work starts, a before-and-after photo record of every duct run, and the 365-Day Done Right Promise in writing when the job is complete. Those aren’t marketing claims – they’re deliverables you can point to if something isn’t right.
The technicians who show up at your Plano home are background-checked, uniformed, and identified by name before arrival – Haven Standard Clause 3: Verified Crews. Equipment on the job includes Rotobrush mechanical agitation systems and Nikro negative-pressure extraction, professional-grade tools you can look up independently. We don’t name equipment in our marketing to impress you; we name it so you can verify what’s being used before agreeing to a price.
Since 2013, CleanRun has completed full system cleanings in more than 52,000 homes, every one with a written price before work started and a documented photo record when the crew left. That’s the practice, not the exception.
For homeowners researching CleanRun Air Duct Cleaning Plano before making contact, that record is the clearest thing we can point to. Twelve years of documented jobs in the Dallas-Fort Worth market, including Plano neighborhoods from Willow Bend to Haggard Farm, with a written guarantee on every one.
Call (469) 452-7766 to schedule your full system cleaning in Plano. You’ll receive a written price before the first panel comes off – that’s not a policy we can override, it’s how the job works.
Written by Tomas Reyes, Owner at CleanRun Air Duct Cleaning Plano, serving Plano.